Pour 1/2 cup baking soda, followed by 1/2 cup vinegar down drain. Plug drain and let sit for one hour. Then, pour a pot of boiling water down drain. Repeat if necessary.
First, remove all stagnant water from the sink. Replace it with hot water until it is halfway full, and it generates a seal around your drain. Place the sink plunger over the drain and start pumping up and down swiftly. Remove the plunger, observe if the water flows, and repeat the procedure until water flows freely.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
Try pouring hot water down the drain, then follow it with one cup of bicarbonate of soda and a cup of vinegar. Leave it for ten minutes, then chase it with more hot water. A combination of the hot water and the natural cleaner mixture can break blockages up.
If you suspect a grease clog, a mixture of very hot water and vinegar can also help melt and remove the grease that's blocking the pipes. Allow it to work for a few minutes, then use a plunger to help move the clog along. You may have to repeat this more than once.
It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain. Always flush this mixture down with boiling water—no matter how long you leave it sitting in the drain.
While hot water can help loosen up debris, coarse salt actually scours the inside of your pipes, removing more material than hot water alone. After removing standing water from the sink, pour about half a cup of table salt down the drain before you pour in the hot water.
Pour boiling hot water down the drain. This can dissolve mildew, slime, soap scum, and other similar clogs. Put half a cup of baking soda in the drain, then pour half a cup of vinegar down after it. Let this mixture sit for an hour, and then check the drain.
Baking Soda and Vinegar
We suggest that you mix 1/3 of a cup of baking soda with 1/3rd of a cup of vinegar to create your drain unblocking remedy. When mixing the two ingredients, they should start to fizz straight away so you should waste no time pouring the concoction straight down your sink.
Pour the mixture into the drain.
Allow it to sit for 15 minutes so the clog can absorb as much as possible. For especially stubborn clogs, let the clog soak for 30 minutes. If you are unable to remove the stopper, add more vinegar to the mixture before pouring so it's thinner.
Pouring boiling water is quite risky as it might lead to a steam burn or scalding. Another thing to keep in mind is what type of material you are pouring in into. If you have a porcelain sink, it is likely to crack due to the heat. All in all, pouring boiling water down your drain will only cause issues down the road.
Green Gobbler Drain Clog Dissolver
It has an ultra-thick formula and can sink through standing water to liquefy clogs. Green Gobbler comes in a unique dual-chambered bottle and is suitable for kitchen drains, shower drains and toilets.
Drano Max Gel Clog Remover
In just 15 minutes, our pick for the best drain cleaner, Drano Max Gel, will clear up clogs in sinks, tubs, PVC, septic tanks, and garbage disposals. It's safe for piping and septic systems, with a thick gel that sinks into standing water to the source of the clog.
Deploy Drano. Does this particular clog seem bust-up proof? If standing water remains, use Drano® Max Gel Clog Remover. It pours straight through the water and attacks the clog directly.
Baking Soda & Vinegar
Clear the area around your sink and put a 1/2 cup of baking soda down the drain. Follow that with a 1/2 cup of vinegar. Now plug your drain and let it sit for an hour. Then, unplug the drain and pour a pot of boiling water down it.
You may be surprised to learn that pouring soda down the drain does work for some clogs. To be specific, you need a dark-colored cola (such as Coca-Cola or Pepsi). This type of carbonated beverage usually contains a good amount of phosphoric acid, which given enough time, can eat away at some types of clogs.
What if The Baking Soda & Vinegar Hack Doesn't Work? If your drain doesn't unclog right away, repeat the baking soda & vinegar process another time or two. If you have a stubborn clog, sometimes the baking soda & vinegar trick just doesn't work. You may have to use a sink plunger to help push through the blockage.
Baking soda powder will turn into a cement like mass and completely clog everything it settles in. I had a family member dump about three cups down the kitchen sink this summer and I ended up having to replace the trap, tailpiece and dishwasher drain inflow.
A lot of folks know the baking soda and vinegar trick. Simply pour some hot water down your clogged drain and follow it up with equal parts baking soda and vinegar (baking soda first), cover the drain with a plug if you have one, let it sit for 20-30 minutes, then follow it up with more hot water to clear the clog.
Once a week, flush your drain by boiling a large pot of water. Pour one-half of the pot down the drain. Wait five minutes and pour the rest. It's a simple thing that can help dislodge any grease or debris lurking in your drain.
In modern houses some of the drain pipes are PVC plastic, and usually the boiling water will just flow through it without causing any damage. But if it goes through the pipe slowly the PVC could the deform.
Use Baking Soda and Vinegar
Pour a ½ cup of regular household baking soda into the drain, then add a ½ cup white vinegar. Cover the drain if you can. Let the mixture stand in the drain for several minutes. Next, to remove grease and debris in your pipes, pour five or six cups of boiling water into the drain.